Batimix Putty 910-Coarse

Description

BATIMIX Putty 910-Coarse is a high quality, coarse putty used for preparing substrates prior to painting. This product adheres really well to applied concrete substrates and BATIMIX sealers.

Main Purpose

BATIMIX Putty 910-Coarse is applied to different kinds of surfaces, like walls, ceilings, wood, and concrete. It is suitable for indoor and outdoor applications.

Features

• Applies easily and has no unpleasant odor
• Superior adhesion
• Provides a protective coating with high abrasion resistance
• Provides a mildew-resistant coating

Properties

• Vehicle type : Vinyl latex
• Recommended wet film thickness : 400 µm
• Recommended dry film thickness : 230 µm
• Drying time at 20 °C (To touch) : 30 - 60 min
• Drying time at 20 °C (To re-coat): 1-2 hours
• Drying time at 20 °C (To fully cure): 7 days
• Dries by : Evaporation, coalescence
• Solid content : 78% ± 3
• PVC : 92% ± 3
• Specific gravity : 1.9 ± 0.1
• pH: 9 ±1
• Minimum surface temperature at application: 16°C
• Maximum surface temperature at application: 32°C
• Volatil Organic Content (VOC) level: Low

Health and Safety

Ensure adequate room ventilation before applying BATIMIX Putty 910-Coarse. Do not breathe spray mist and sanding dust. Avoid contact with eyes and prolonged or repeated contact with skin. Wear eye protection and gloves during application or sanding. Close the container after each use and wash thoroughly after handling.

First Aid: In case of eye contact, flush with water for 15 minutes. For skin contact, wash with soap and water. If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.

For additional safety directions, kindly refer to the corresponding Material Safety Data Sheet.

Directions For Use

Application: BATIMIX Putty 910 - Coarse is normally applied using a trowel. Do not apply when air and/or surface temperature are below 16 °C. The average coverage rates are around 1.3 m²/kg and depend on the method of application, degree of substrate porosity, and absorption level.

For maximum adhesion, BATIMIX Putty 910-Coarse can be applied on previously prepared surfaces, especially those possessing high absorbance.

Precautions: Wash with care to avoid scuffing and burnishing. Refrain from washing walls before paint has fully cured.

Warning: If you scrape sand or remove old paint, you may release lead dust, which is known for its high toxicity. Exposure to lead can cause serious illnesses and brain damage especially to children and pregnant women.

Storage

BATIMIX Putty 910-Coarse has a minimum shelf life of 12 months, if kept unopened. It must be stored at temperatures ranging from 5 to 40 °C. It should not be subjected to direct sunlight

Packages

• 25 kg plastic pail
• 6 kg plastic pail