Batimix Putty 900-Fine

Description

BATIMIX Putty 900-Fine is a high quality, fine putty used for preparing substrates prior to painting. It adheres really well to applied BATIMIX sealer.

Main Purpose

BATIMIX Putty 900-Fine is applied to different kinds of surfaces, like walls, ceilings, wood, and concrete. It is suitable for indoor and outdoor applications.

Features

• Applies easily and has no unpleasant odor
• Exceptionally easy to apply
• Superior adhesion resistances
• Provides a protective coating with high resistance against abrasion
• Provides a mildew-resistant coating

Properties

• Vehicle type : Vinyl Acetate latex
• Recommended wet film thickness: 250 µm
• Recommended dry film thickness : 130 µm
• Drying time at 20 °C (To touch) : 30 - 60 min
• Drying time at 20 °C (To re-coat) : 1-2 hours
• Drying time at 20 °C (To fully cure) : 7 days
• Dries by : Evaporation, coalescence
• Solid content : 75% ± 3%
• PVC : 90% ± 3%
• Specific gravity: 1.8 ± 0.1
• pH : 9 ± 1
• Minimum surface temperature at application: 16°C
• Maximum surface temperature at application: 32°C
• Volatil Organic Content (VOC) level: Low

Health and Safety

Ensure adequate room ventilation when applying BATIMIX Putty 900-Fine. Do not breathe spray mist and sanding dust. Avoid contact with eyes and prolonged or repeated contact with skin. Wear eye protection and gloves during application or sanding. Close the container after each use and wash thoroughly after handling.

First Aid: In case of eye contact, flush with water for 15 minutes. For skin contact, wash with soap and water. If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.

For additional safety directions, kindly refer to the corresponding Material Safety Data Sheet.

Directions for Use

Application: BATIMIX Putty 900-Fine is normally applied using a trowel. Do not apply when air and/or surface temperature are below 16 °C. The average coverage rates are around 2 m²/kg, depending on the method of application, degree of substrate porosity, absorption level, etc.

For maximum adhesion, BATIMIX Putty 900-Fine can be applied on previously prepared surfaces, especially those possessing high absorbance.

Precautions: Wash with care to avoid scuffing and burnishing. Refrain from washing walls before paint has fully cured.

Warning: If you scrape sand or remove old paint, you may release lead dust, which is known by its high toxicity. Exposure to lead can cause serious illness such as brain damage especially to children and pregnant women.

Storage

BATIMIX Putty 900-Fine has a minimum shelf life of 12 months, if kept unopened. It must be stored at temperatures ranging from 5 to 40 °C. It should not be subjected to direct sunlight.

Packages

• 25 kg plastic pail
• 6 kg plastic pail