Batimix Mortar 600

Description

BATIMIX Mortar 600 is a pre-packaged ready-to-use cementitious-based non-shrink grout. It is designed from Type I Portland cement, carefully graded sand, and selected additives, which improve positive expansion, workability, water repellency, and adhesion against substrates.

Main Purpose

BATIMIX Mortar 600 is used to fill narrow holes and small joints of less than 4 mm, for interior and exterior elements. Main applications include the grouting of supports beneath load-bearing units, column-based plates, anchors, dowels, and beams.

Features

BATIMIX Mortar 600 has the following characteristics:

• Strong adhesion to substrates
• Non-staining, it offers a similar appearance to parent concrete and mortar surfaces
• High compressive and flexural characteristics
• Positive expansion, which eliminates all types of shrinkage problems and surface cracks
• Reduced level of water penetration from the absence of potential cracks
• Enhanced durability of the finished product.

Properties

• Appearance : powder
• Bulk density: approx. 1.42
• Grain size: 0 to 2 mm
• Wet mix life : around 30 minutes at 23 °C
• Early age height change (Adapted ASTM C 827): + 1.8%
• Height change of hardened grout (ASTM C 1090): + 2.3%
• Compressive strength at 28 days (ASTM C 109): Minimum 48 MPa
• Flexural strength at 28 days (ASTM C 348): Minimum 7.7 MPa
• Pull-off strength against concrete at 28 days (EN 1015-12): Minimum 1.1 MPa
• Water permeability after 48 hours (EN 1015-21): 0.46 ml / cm²

Health and Safety

BATIMIX Mortar 600 contains cement that is irritating to the eyes and skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Wear suitable gloves. For further information, kindly refer to Material Safety Data Sheet.

Directions for Use

Substrate preparation: BATIMIX Mortar 600 must be applied on sound and thoroughly cleaned substrates free of oil, dust, loose particles, and paints. The traces of mould joints must be leveled. All surfaces should be saturated with water (SSD condition) prior to application.

Product preparation: Depending on the desired consistency, a 25-kg bag of BATIMIX Mortar 600 is mixed manually or mechanically with 3.5 to 4.25 liters of clean water until a homogenous mix is obtained. Do not add sand or other cement admixtures so as not to alter product characteristics.

Application: BATIMIX Mortar 600 may be applied by various methods including manually with a plastering trowel and spraying. The average consumption rates vary from 14 to 18 kg / m² / cm, depending on the method of application and type of substrate. During application, any machinery adjacent to the grouting operations which might cause vibration must be shut down until the grout has reached final setting.

Protection and curing: The temperature during application should be between 5 and 40 °C. When finishing, the grout should be protected from extreme temperatures, wind, and sunshine by moist curing for a minimum of 3 days.

Specifications / Compliance with Standards

BATIMIX Mortar 600 is manufactured to conform to all current requirements of ASTM C 1107 Grade C for Standard specification for packaged dry, hydraulic-cement grout (non-shrink).

Storage

BATIMIX Mortar 600 shelf life is six months from the production date if well stored in a closed dry place. Avoid freezing and excessive temperatures.

Packages

• 50 kg paper bag