Batimix Masonry Binder 30 - White

Description

BATIMIX Masonry Binder 30 - White is a white hydraulic binder with enhanced properties. It is particularly suitable for spatter-dash slurry coat applications in masonry construction. It is made from a blend of cement and fillers combined with selected chemical additives such as plasticizing / water-reducing, air-entraining, and viscosity-enhancing agents.

Main Purpose

BATIMIX Masonry Binder 30 - White is especially recommended for producing spatter-dash slurry coat mortars for increasing the roughness of smooth substrates before plastering interior and exterior elements. The binder promotes the uniformity of prepared mortars while reducing the amount of rebound during application. It can also be used for preparing mortars for assembling masonry units, plastering, and rendering works.

Features

BATIMIX Masonry Binder 30 - White is used to preparing mortars for masonry works, which have the following characteristics:

• good workability, from the presence of fillers and plasticizing agents,
• high water retention that prevents rapid loss of mixing water,
• low volume changes, such as the drying shrinkage and sulfate expansion, and
• high coverage ratios, mainly due to the lower products' densities.

Properties

• Appearance : Powder
• Specific gravity: 2.96
• Chloride content : nil
• Fineness # 325 sieve (C 430): 15%
• Autoclave expansion* (C 151): 0.5 mm
• Gillmore initial set time (C 266): 115 minutes
• Gillmore final set time (C 266): 240 minutes
• Water retention (C 91): 85%
• Air content (C 185): 8.4%
• Compressive strength at 7 d (C 109): 19.6 MPa
• Compressive strength at 28 d (C 109): 28.5 MPa
• Flexural strength at 28 d (C 348): 3.0 MPa
• Blaine specific surface (C 204): 355 m²/kg

Health and Safety

BATIMIX Masonry Binder 30 - White contains cement that is irritating to the eyes and skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. Wear suitable gloves. For further information, please refer to Material Safety Data Sheet.

Directions for Use

Depending on the type of substrate and desired strength, one part of BATIMIX Masonry Binder 30 - White should be mixed with 2 to 3 parts, by volume, of well graded natural and/or crushed sand. The water should be clean and just enough to obtain a fluid consistency.

Mortars made with BATIMIX Masonry Binder 30 - White can be applied manually using a traditional trowel or mechanically with a projection-spraying device. Appropriate curing procedures are important to ensure the quality and durability of the so-prepared mortars. For detailed application instructions, kindly refer to the product’s “Application Guidelines”.

Specifications / Compliance with Standards

BATIMIX Masonry Binder 30 - White is manufactured to conform to all current requirements of EN 413-1 MC 22.5 for Masonry Cement and ASTM C 1328 Type M for Plastic (Stucco) Cement.

Caution

BATIMIX Masonry Binder 30 - White is not an ordinary Portland cement, and cannot be used for concreting works. It can solely be used to produce mortars for masonry construction.

Storage

BATIMIX Masonry Binder 30 - White shelf life is six months from the production date if well stored in a closed dry place. Avoid freezing and excessive temperatures.

Packages

• 1 t big bag
• 50 kg paper bag
• 25 kg paper bag