Batimix ILS-120 Semi-Gloss

Description

BATIMIX ILS-120 Semi-Gloss is a premium quality low shade vinyl paint. This paint provides a high quality finish that can be washed clean with soap and water, and creates a decorative and protective surface that resists the adsorption of stains.

Main Purpose

BATIMIX ILS-120 Semi-Gloss paint is mainly used indoors in living rooms, bedrooms, and dining rooms. It can be applied on drywalls, cement plaster, concrete walls, and previously painted surfaces.

Features

• An attractive, washable semi-gloss finish
• Exceptionally easy to apply
• Fast, simple clean up with minimum wet rubbing
• Superior spatter resistance for application by roller
• Offers exceptional hiding and sealing
• Resistant to soaps, detergents, and household cleaners
• Provides a mildew resistant coating

Properties

• Binder type : Vinyl latex
• Solid content (by weight): 57% ± 2
• Recommended wet film thickness/coat : 100 µm
• Recommended dry film thickness/coat : 41 µm
• Drying time at 20 °C (To touch) : 30-60 min
• Drying time at 20 °C (To re-coat) : 1-2 hours
• Drying time at 20 °C (To fully cure) : 7 days
• Dries by : Evaporation, coalescence
• Viscosity (S4/10/25°C) : 5,580 cP ± 1,000
• PVC : 26% ± 2
• Specific gravity : 1.3 ± 0.05
• pH : 9.5 ± 0.5
• 60° Gloss : 40-60
• Minimum surface temperature at application: 10°C
• Maximum surface temperature at application: 32°C
• Thin with : Clean water

Health and Safety

Painting with BATIMIX ILS-120 Semi-Gloss paint should be done with adequate ventilation. Do not breathe spray mist and sanding dust. Avoid contact with eyes and prolonged or repeated contact with skin. Wear eye protection and gloves during application or sanding. Close the container after each use and wash thoroughly after handling.

First Aid: In case of eye contact, flush with water for 15 minutes. For skin contact, wash with soap and water. If you experience difficulty breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately.

For additional safety directions, kindly refer to the corresponding Material Safety Data Sheet.

DIRECTIONS FOR USE

Mixing of paint: Stir thoroughly before and during use to ensure homogenous and uniform solution.

Thinning: If necessary, to obtain desired application properties, you may add up to 15% clean water to BATIMIX ILS-120 Semi-Gloss. Stir thoroughly to mix the added water with the paint.

Surface preparation: Surfaces to be painted must be clean and free from dirt, dust, wax, soap, oil, grease, and water-soluble materials. Water dispersed detergents (such as tri-sodium phosphate) and abrasive cleaners are more suitable than solvent-based solutions for surface cleaning. Rinse well to remove residues. Remove any peeling or scaling paint. Apply primer before and after filling nail holes, cracks, and other surface imperfections.

Unpainted surfaces: As mentioned above, the surface must be clean and thoroughly brushed with stiff fiber bristles to remove loose particles.

Repainted surfaces: Remove any peeling or scaling paint, and sand these areas to featheredges smooth with adjacent surfaces.

Primer: For maximum adhesion strength, you may use BATIMIX primers before applying the paint.

Application: BATIMIX ILS-120 Semi-Gloss can be applied by brush, roller or airless spray. When using an airless spray, thinning may be required depending on the equipment used and the application conditions. Do not apply when air and/or surface temperature are below 10 °C. Apply one or two coats, if needed. The average spreading rate per coat is around 10 m2/liter, depending on the method of application, degree of substrate porosity and absorption level, etc.

Precautions: Wash with care to avoid scuffing and burnishing. Refrain from washing walls before paint is fully cured.

Storage

BATIMIX ILS-120 Semi-Gloss has a minimum shelf life of 12 months if kept unopened. It must be stored at temperatures ranging from 5 to 40 °C. It should not be subjected to direct sunlight.

Packages

• 5 US gallon plastic pail
• 1 US gallon plastic pail